nowhereman9499
About
- Username
- nowhereman9499
- Joined
- Visits
- 0
- Last Active
- -
- Roles
- member
- Badges
- 0
- Posts
- 12
Reactions
Comments
-
Ok, here are the test results for the cinebench test: plugged in: Open GL 5.74fps and CPU 1.43 pts battery: Open GL 5.74 fps and CPU 1.44 pts For the xbench test, the results are: plugged in: 143.96 battery: 137.51 I have no idea what this…
-
Ok, here are the test results for the cinebench test: plugged in: Open GL 5.74fps and CPU 1.43 pts battery: Open GL 5.74 fps and CPU 1.44 pts For the xbench test, the results are: plugged in: 143.96 battery: 137.51 I have no idea what thi…
-
I've downloaded them and will try them in the morning. I get up for work a 2am so time for bed, but I'll post what the results were here ASAP. Thanks! Quote: Originally Posted by Marvin You're not alone either. Someone else posted on the forum…
-
Sorry for the late reply but I've been so frustrated over this. Apparently no one else can figure it out either. I took it back to the repair place that worked on it before and after running more tests, they found nothing wrong, not even the battery…
-
Quote: Originally Posted by Marvin So it has only started doing this since they repaired the logic board? If that's the case, you should send it back to them to fix. You shouldn't have to be the one to put up with or diagnose a hardware fault. …
-
Quote: Originally Posted by Marvin It seems unlikely that would be the case. When did it start doing this? Did the Apple repair people try replacing the battery itself? If they didn't, you can always buy one yourself and try it and if it doesn…
-
posted in wrong spot, sorry... Ok, So I rebooted the laptop in safe mode and when unplugged, it responded the same way. Also ran the hardware test through the install disk and it came up with no error either. Also retried the SMC reset again as w…
-
Quote: Originally Posted by nowhereman9499 Ok I will try this. Hopefully this will narrow down the problem. Ok, So I rebooted the laptop in safe mode and when unplugged, it responded the same way. Also ran the hardware test through the install…
-
Quote: Originally Posted by Marvin You can run a hardware test from your install disc by booting holding the d-key. Also try running your machine in safe mode (boot holding shift) on the battery and see if you get the same slowdown. Ok I wi…
-
Unfortunately the SMC reset did not work. I wonder if the new logic board could be bad as well. Is there a way to test it out?
-
I did not do a SMC reset, truthfully, I did not know that you could do that, but I will try it now and post the outcome of the test in a bit