f2photo
About
- Username
- f2photo
- Joined
- Visits
- 0
- Last Active
- -
- Roles
- member
- Badges
- 0
- Posts
- 7
Reactions
Comments
-
Obviously you did not read the previous post I made. The OS was reinstalled. I have found several boards where people are complaining of the same issues as I am finding. This has upset a good number of people other than myself.
-
To keep updating this story. I cleared the NVRAM/PRAM several times. Eliminated programs that have been on here for a long time. Cleared everything out of the startup agents, etc. And I reinstalled the OS. I can run, but the speed of which is s…
-
MY hardware is an APPLE MacBook Pro with Maverick installed on it that was running fine until yesterday when an upgrade was done from the APPLE store, but somehow they bear no responsibility and it is my fault it is isn't running? Wrong!
-
My Final Cut Pro (10.1.1), Dreamweaver, HP Scan, Flip4Mac (yeah somewhat outdated anyway) dont work at all after the upgrade, as well as, a host of new issues that this OS has. I have yet to see the pinwheel stop. It is taking forever to do anythi…
-
No but the hard drive needing repair, the drives disconnecting, the 4 to 5 minute boot time, the 30 seconds to 2 minutes to open ANY application while the pinwheel of slowness turns, the need for an SMC reset and the wireless device disconnecting n…
-
The upgrade left the disk in disrepair. Do a repair mode and SMC reset... sure looks like Apple to me. THe boards are full of the HP Scan not working and Dreamweaver not working.